Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Problem getting Crown body mount to fit
Reply to thread
Message
<blockquote data-quote="TRevs" data-source="post: 440032" data-attributes="member: 20654"><p>I’m replacing the two body mounts in the crossmember in front of the fuel tank (I’ll get to the rest of them later), and the new rubber isolator doesn’t seem to fit through the opening in the crossmember.</p><p></p><p>I’m using Crown 5200 2660, which I confirmed is the part number from the Factory parts list. The metal post fits nicely into the rubber isolator, but even with silicone grease and the entire weight of the tub on it, it wont fully seat through the crossmember. It is holding the tub up off the two nearest mounts:</p><p></p><p></p><p></p><p></p><p>[ATTACH=full]122103[/ATTACH]</p><p></p><p>[ATTACH=full]122104[/ATTACH]</p><p></p><p>Ideas? Should the rubber go in first then get the metal cap on last?</p></blockquote><p></p>
[QUOTE="TRevs, post: 440032, member: 20654"] I’m replacing the two body mounts in the crossmember in front of the fuel tank (I’ll get to the rest of them later), and the new rubber isolator doesn’t seem to fit through the opening in the crossmember. I’m using Crown 5200 2660, which I confirmed is the part number from the Factory parts list. The metal post fits nicely into the rubber isolator, but even with silicone grease and the entire weight of the tub on it, it wont fully seat through the crossmember. It is holding the tub up off the two nearest mounts: [ATTACH type="full" alt="IMG_1706.jpeg"]122103[/ATTACH] [ATTACH type="full" alt="IMG_1707.jpeg"]122104[/ATTACH] Ideas? Should the rubber go in first then get the metal cap on last? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Problem getting Crown body mount to fit
Top
Bottom