Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Photo of stock rear driveshaft and angle (stock height)
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 441632" data-attributes="member: 18789"><p>Anybody have a photo of a bone stock rig they can share a photo of the rear driveshaft from? Bonus points if it's a 6 cyl manual. I'm asking because I converted back to stock height and Dana 35. When I look at the driveshaft angle, it seems somewhat steep. But, it's been a very long time since I was stock, so maybe my memory is just misremembering.</p><p></p><p>The springs are near-flat like stock so I know I didn't end up sitting inches higher like some of the "stock" advertised springs result in. Everything else is completely stock, so it is probably fine. It just seemed steeper than I remember. </p><p></p><p>[ATTACH=full]122660[/ATTACH]</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 441632, member: 18789"] Anybody have a photo of a bone stock rig they can share a photo of the rear driveshaft from? Bonus points if it's a 6 cyl manual. I'm asking because I converted back to stock height and Dana 35. When I look at the driveshaft angle, it seems somewhat steep. But, it's been a very long time since I was stock, so maybe my memory is just misremembering. The springs are near-flat like stock so I know I didn't end up sitting inches higher like some of the "stock" advertised springs result in. Everything else is completely stock, so it is probably fine. It just seemed steeper than I remember. [ATTACH type="full" width="1175px" alt="IMG_3866.JPG"]122660[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Photo of stock rear driveshaft and angle (stock height)
Top
Bottom