Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Noid light help
Reply to thread
Message
<blockquote data-quote="jpjeep26uk" data-source="post: 441647" data-attributes="member: 20690"><p>Hi, I've bought a noid light to test my Injector. Looked elsewhere on here for help but they are quite old posts so apologies for resurrecting.</p><p></p><p>Plugged the noid in to the harness and cranked the Jeep, no light.</p><p>I've read that light is good and no light is bad ?</p><p>The ECU is sending a pulse to the injector out of pin 21 on crank as I've plugged a tester in and it lights up.</p><p></p><p>Could it be a bad ground wire in/ out of the injector connector?</p><p>If so, how do I test that please?</p><p></p><p>Ive traced it to the OBD 1 diagnostic yellow box but don't know how to test anything to see if it's shorting or faulty? </p><p>It's spliced to about 5 other orange wires that head off to different connections, one of which goes through the firewall to the fuse box, but they all seem to be visually ok.</p><p></p><p>Thanks folks.</p><p></p><p>[ATTACH=full]122669[/ATTACH]</p><p></p><p>[ATTACH=full]122670[/ATTACH]</p></blockquote><p></p>
[QUOTE="jpjeep26uk, post: 441647, member: 20690"] Hi, I've bought a noid light to test my Injector. Looked elsewhere on here for help but they are quite old posts so apologies for resurrecting. Plugged the noid in to the harness and cranked the Jeep, no light. I've read that light is good and no light is bad ? The ECU is sending a pulse to the injector out of pin 21 on crank as I've plugged a tester in and it lights up. Could it be a bad ground wire in/ out of the injector connector? If so, how do I test that please? Ive traced it to the OBD 1 diagnostic yellow box but don't know how to test anything to see if it's shorting or faulty? It's spliced to about 5 other orange wires that head off to different connections, one of which goes through the firewall to the fuse box, but they all seem to be visually ok. Thanks folks. [ATTACH=full]122669[/ATTACH] [ATTACH=full]122670[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Noid light help
Top
Bottom