Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
No power to the fuel pump?
Reply to thread
Message
<blockquote data-quote="TimberTim" data-source="post: 435933" data-attributes="member: 20208"><p>I just went through a similar situation with my 91 yj , the starter motor would turn the engine over nice and strong but the engine would'nt run. turns out while I was replacing freeze plugs the CPS (crank position sensor) plug got knocked loose. A little wiggle on the plug and a push in to securely fasten it was all it took and it fired right up, Since you removed your bell housing you might check your installation of the CPS</p></blockquote><p></p>
[QUOTE="TimberTim, post: 435933, member: 20208"] I just went through a similar situation with my 91 yj , the starter motor would turn the engine over nice and strong but the engine would'nt run. turns out while I was replacing freeze plugs the CPS (crank position sensor) plug got knocked loose. A little wiggle on the plug and a push in to securely fasten it was all it took and it fired right up, Since you removed your bell housing you might check your installation of the CPS [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
No power to the fuel pump?
Top
Bottom