Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Need donor models and years to replace the dreaded Dana 30 split axle
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 436524" data-attributes="member: 18789"><p>You'll want the full axle shafts, 97+ have larger better u-joints (5-760x from Spicer). As such, you'll need the full shaft, both the main long one and the stub that goes into the unit bearing.</p><p></p><p>In order for your new one to match the driver side, you're best off getting both passenger and driver shafts, and the corresponding stubs. You can probably order all of this off eBay for not too terrible of a price. I found mine in a junkyard for about $105 if I remember right.</p><p></p><p>If you want your 4x light to work, you'll want to take the wiring from the CAD motor and extend it to the transfer case, install a TJ transfer case switch (J8134473) in place of the vacuum switch, and a CON138 or SKS712 connector pigtail to plug it in.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 436524, member: 18789"] You'll want the full axle shafts, 97+ have larger better u-joints (5-760x from Spicer). As such, you'll need the full shaft, both the main long one and the stub that goes into the unit bearing. In order for your new one to match the driver side, you're best off getting both passenger and driver shafts, and the corresponding stubs. You can probably order all of this off eBay for not too terrible of a price. I found mine in a junkyard for about $105 if I remember right. If you want your 4x light to work, you'll want to take the wiring from the CAD motor and extend it to the transfer case, install a TJ transfer case switch (J8134473) in place of the vacuum switch, and a CON138 or SKS712 connector pigtail to plug it in. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Need donor models and years to replace the dreaded Dana 30 split axle
Top
Bottom