Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Need cooling help: 2.5 runs over 220 degrees
Reply to thread
Message
<blockquote data-quote="f4u5t" data-source="post: 425882" data-attributes="member: 18833"><p>so the thermostat i removed (195) was stuck open, the one I replaced it with (180 ) neither had that hole, And i did find the block had air trapped....I have since removed the thermostat altogether, and ensure the water is full by removing the temp sensor and allowing water to come out that....</p><p>Im not sure about the plug on the block, ill have to research where that is...</p><p>today i plan to get some "flush" from the autoparts store and run that for a bit, then dump it again - before i just replace the Rad.</p></blockquote><p></p>
[QUOTE="f4u5t, post: 425882, member: 18833"] so the thermostat i removed (195) was stuck open, the one I replaced it with (180 ) neither had that hole, And i did find the block had air trapped....I have since removed the thermostat altogether, and ensure the water is full by removing the temp sensor and allowing water to come out that.... Im not sure about the plug on the block, ill have to research where that is... today i plan to get some "flush" from the autoparts store and run that for a bit, then dump it again - before i just replace the Rad. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Need cooling help: 2.5 runs over 220 degrees
Top
Bottom