Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Multifunction combination switch
Reply to thread
Message
<blockquote data-quote="cdhulin" data-source="post: 439709" data-attributes="member: 21259"><p>Update on my jeep. I bought a new switch. It was not the switch that was bad. I was able to use the old switch and just depress where the rod goes into it to switch to dims. I did end up putting new switch on as old one is close to 28 years old. I figure if I have to tear it down it's getting replaced since I don't want to do it twice. When I put the new switch on I did try to change from brights to dims but noticed the rod was not being actuated. So I removed the steering wheel and noticed a piece of another switch was broken. Is this the wiper switch? Its where my stalk attaches to. On a side note I cannot remove the stalk. I have twisted it and pulled, pulled it, twisted it the other way and pulled it. That thing just won't budge. Under the red wire in the rectangle hole is where the piece broke off. I guess that is what pushes the rod to activate the dimmer switch. </p><p></p><p>Thank yall for the help and yall time. I greatly appreciate it.</p><p></p><p>[ATTACH=full]121937[/ATTACH]</p><p></p><p>[ATTACH=full]121938[/ATTACH]</p></blockquote><p></p>
[QUOTE="cdhulin, post: 439709, member: 21259"] Update on my jeep. I bought a new switch. It was not the switch that was bad. I was able to use the old switch and just depress where the rod goes into it to switch to dims. I did end up putting new switch on as old one is close to 28 years old. I figure if I have to tear it down it's getting replaced since I don't want to do it twice. When I put the new switch on I did try to change from brights to dims but noticed the rod was not being actuated. So I removed the steering wheel and noticed a piece of another switch was broken. Is this the wiper switch? Its where my stalk attaches to. On a side note I cannot remove the stalk. I have twisted it and pulled, pulled it, twisted it the other way and pulled it. That thing just won't budge. Under the red wire in the rectangle hole is where the piece broke off. I guess that is what pushes the rod to activate the dimmer switch. Thank yall for the help and yall time. I greatly appreciate it. [ATTACH=full]121937[/ATTACH] [ATTACH=full]121938[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Multifunction combination switch
Top
Bottom