Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Jeep yj crank but no start
Reply to thread
Message
<blockquote data-quote="akopp1652" data-source="post: 439271" data-attributes="member: 21213"><p>I was driving to work the other day and the yj just shut off on me, the check engine light came on and when i turned off the ignition and turned it back on the check engine light was gone. i checked for spark and there was none. i've replaced the distributor cap, distributor rotor, ignition coil and the crankshaft position sensor and still no change. frustrated i went and bought an OBD 1 reader and it threw 4 codes at me the first was that the o2 sensor was shorted out and i looked and the wires had melted against the engine block exhaust so as a temporary fix i wrapped the wires in electrical tape and the code for the o2 sensor disappeared. the other codes are (code 22) - coolant temp sensor signal voltage out of range (code 23) - intake air, air charge or throttle throttle body temp sensor voltage signal out of range (code 24)- throttle position sensor signal voltage out of range. Would any of these codes cause the yj to crank but not start?</p></blockquote><p></p>
[QUOTE="akopp1652, post: 439271, member: 21213"] I was driving to work the other day and the yj just shut off on me, the check engine light came on and when i turned off the ignition and turned it back on the check engine light was gone. i checked for spark and there was none. i've replaced the distributor cap, distributor rotor, ignition coil and the crankshaft position sensor and still no change. frustrated i went and bought an OBD 1 reader and it threw 4 codes at me the first was that the o2 sensor was shorted out and i looked and the wires had melted against the engine block exhaust so as a temporary fix i wrapped the wires in electrical tape and the code for the o2 sensor disappeared. the other codes are (code 22) - coolant temp sensor signal voltage out of range (code 23) - intake air, air charge or throttle throttle body temp sensor voltage signal out of range (code 24)- throttle position sensor signal voltage out of range. Would any of these codes cause the yj to crank but not start? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Jeep yj crank but no start
Top
Bottom