Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Idle Air Control Valve
Reply to thread
Message
<blockquote data-quote="Tucker" data-source="post: 429190" data-attributes="member: 19516"><p>I didn't spray anything. Just pulled old sensor off and put new one on. O-ring is in place. The new sensor didn't come with a gasket, just the o-ring. Maybe it isn't tighten down enough? Probably just pull off the throttle body and clean it all out. The IAC was pretty filthy so I imagine the rest of it is as well. I can replace the TPS at the same time. Fingers crossed.</p></blockquote><p></p>
[QUOTE="Tucker, post: 429190, member: 19516"] I didn't spray anything. Just pulled old sensor off and put new one on. O-ring is in place. The new sensor didn't come with a gasket, just the o-ring. Maybe it isn't tighten down enough? Probably just pull off the throttle body and clean it all out. The IAC was pretty filthy so I imagine the rest of it is as well. I can replace the TPS at the same time. Fingers crossed. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Idle Air Control Valve
Top
Bottom