Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Idiot lights on dash power source
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 441540" data-attributes="member: 18789"><p>Turn signal switch won't tell anything - if you have front turn signals then you're good at the switch because that is the same circuit that feeds the idiot light. Need to test the pins at the plug that goes to the idiot light cluster to see if you have power there or not. It is most likely corrosion on the connector. It would be very unusual for the high beam, left turn, and right turn to all have broken inside the harness which is protected by loom and tape.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 441540, member: 18789"] Turn signal switch won't tell anything - if you have front turn signals then you're good at the switch because that is the same circuit that feeds the idiot light. Need to test the pins at the plug that goes to the idiot light cluster to see if you have power there or not. It is most likely corrosion on the connector. It would be very unusual for the high beam, left turn, and right turn to all have broken inside the harness which is protected by loom and tape. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Idiot lights on dash power source
Top
Bottom