Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
How difficult is it to get OE inner fender panels to fit on aftermarket tube fenders?
Reply to thread
Message
<blockquote data-quote="Walt Jaquith" data-source="post: 426388" data-attributes="member: 18654"><p>Heh. It is on my list to pull one off and make a pattern, but at the moment I'm in the middle of becoming an expert on 30 year old GM EFI systems figuring out how get my 4.3L franken-motor in top tune. A quick measurement says a chunk of rubber 39" x 21" would be big enough to make one.</p></blockquote><p></p>
[QUOTE="Walt Jaquith, post: 426388, member: 18654"] Heh. It is on my list to pull one off and make a pattern, but at the moment I'm in the middle of becoming an expert on 30 year old GM EFI systems figuring out how get my 4.3L franken-motor in top tune. A quick measurement says a chunk of rubber 39" x 21" would be big enough to make one. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
How difficult is it to get OE inner fender panels to fit on aftermarket tube fenders?
Top
Bottom