Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Half-door Fitment
Reply to thread
Message
<blockquote data-quote="Flyer58" data-source="post: 436808" data-attributes="member: 18629"><p>I thought the same about my full doors until I removed the hinge plates and then it fit properly all the way around. Holding the door in place I then attached the hinged plates and tightened the screws. </p><p></p><p>If those paltes don't move around an all directions then you'll not get it to fit.</p><p></p><p>Yes for PB Blaster and keep adding some a few times a day. I think it dries out a little fast. Heat is what really breaks the bond.</p></blockquote><p></p>
[QUOTE="Flyer58, post: 436808, member: 18629"] I thought the same about my full doors until I removed the hinge plates and then it fit properly all the way around. Holding the door in place I then attached the hinged plates and tightened the screws. If those paltes don't move around an all directions then you'll not get it to fit. Yes for PB Blaster and keep adding some a few times a day. I think it dries out a little fast. Heat is what really breaks the bond. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Half-door Fitment
Top
Bottom