Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Evap system workaround help
Reply to thread
Message
<blockquote data-quote="CostaRicaYJ" data-source="post: 440697" data-attributes="member: 21301"><p>Hello, on my 89 yj 2.5L the evap canister has been removed and I have some high idle issues (1500rpm) I have traced the lines as per attached photo. I have several lines plugged off and a few just open to atmosphere and the pcv line is sucking air like crazy if I plug it with my finger the engine dies. I’m wondering if anyone on here knows a work around to connect what lines together or change what I have going on now to run better. As per first pic “green arrow” port (goes to pcv)sucking air . Port below that open but no vac (at idle) pcv valve is new. How can I make this work without the evap canister as a replacement is non existent in Costa Rica . Second pic is my line rooting I’ve traced ( sorry for the crude dirty pic) Third pic is what I’m referencing</p><p></p><p>[ATTACH=full]122370[/ATTACH]</p><p></p><p>[ATTACH=full]122371[/ATTACH]</p><p></p><p>[ATTACH=full]122372[/ATTACH]</p></blockquote><p></p>
[QUOTE="CostaRicaYJ, post: 440697, member: 21301"] Hello, on my 89 yj 2.5L the evap canister has been removed and I have some high idle issues (1500rpm) I have traced the lines as per attached photo. I have several lines plugged off and a few just open to atmosphere and the pcv line is sucking air like crazy if I plug it with my finger the engine dies. I’m wondering if anyone on here knows a work around to connect what lines together or change what I have going on now to run better. As per first pic “green arrow” port (goes to pcv)sucking air . Port below that open but no vac (at idle) pcv valve is new. How can I make this work without the evap canister as a replacement is non existent in Costa Rica . Second pic is my line rooting I’ve traced ( sorry for the crude dirty pic) Third pic is what I’m referencing [ATTACH=full]122370[/ATTACH] [ATTACH=full]122371[/ATTACH] [ATTACH=full]122372[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Evap system workaround help
Top
Bottom