Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Engine Rebuild Adventure - Advice Needed
Reply to thread
Message
<blockquote data-quote="jthops" data-source="post: 438864" data-attributes="member: 20901"><p>Well, good and bad news. The rod bearings look great (Pic below) - no obvious scoring and smooth surface on the crank. The bad news is that I don't know what's causing the knock. Is it possible that the endplay is causing the knocking? My endplay was just barely in spec when I built the engine - 0.0060". I guess I'll pull the main caps next and look at the bottom of those bearings. I've also been looking at the cylinder walls - nothing stands out.</p><p></p><p>Any other suggestions? Thanks-</p><p></p><p>[ATTACH=full]121620[/ATTACH]</p></blockquote><p></p>
[QUOTE="jthops, post: 438864, member: 20901"] Well, good and bad news. The rod bearings look great (Pic below) - no obvious scoring and smooth surface on the crank. The bad news is that I don't know what's causing the knock. Is it possible that the endplay is causing the knocking? My endplay was just barely in spec when I built the engine - 0.0060". I guess I'll pull the main caps next and look at the bottom of those bearings. I've also been looking at the cylinder walls - nothing stands out. Any other suggestions? Thanks- [ATTACH type="full"]121620[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Engine Rebuild Adventure - Advice Needed
Top
Bottom