Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Driveshaft problem
Reply to thread
Message
<blockquote data-quote="aquaman" data-source="post: 429896" data-attributes="member: 19639"><p>I got a new driveshaft for my 94 yj. After finally getting it (they changed the delivery date 4 times) I went to put it in but it wouldn’t fit. I measured both center to center and measurements are correct. I can jack rear-end up and put the driveshaft in but it is in the fully compressed position. Any suggestions?</p></blockquote><p></p>
[QUOTE="aquaman, post: 429896, member: 19639"] I got a new driveshaft for my 94 yj. After finally getting it (they changed the delivery date 4 times) I went to put it in but it wouldn’t fit. I measured both center to center and measurements are correct. I can jack rear-end up and put the driveshaft in but it is in the fully compressed position. Any suggestions? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Driveshaft problem
Top
Bottom