Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Driveshaft angle?
Reply to thread
Message
<blockquote data-quote="Brian" data-source="post: 433393" data-attributes="member: 19943"><p>So many have relied to my driveline vibration I am not sure where to post this.</p><p>Finally got my new u bolts and replaced old ones because they snapped in trying to loosen them. Got the shim (2.5 deg) turned around that was in backwards. Found center bolt was too short to enter axle (replaced). With all that done and the skid plate shimmed at 3/4" she is smooth as can be. Thanks to all for the advice!</p></blockquote><p></p>
[QUOTE="Brian, post: 433393, member: 19943"] So many have relied to my driveline vibration I am not sure where to post this. Finally got my new u bolts and replaced old ones because they snapped in trying to loosen them. Got the shim (2.5 deg) turned around that was in backwards. Found center bolt was too short to enter axle (replaced). With all that done and the skid plate shimmed at 3/4" she is smooth as can be. Thanks to all for the advice! [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Driveshaft angle?
Top
Bottom