Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Driveshaft angle?
Reply to thread
Message
<blockquote data-quote="Brian" data-source="post: 433264" data-attributes="member: 19943"><p>I will take pics tomorrow and also do a better job of measuring angles. Visually looking at the springs, there is a shim between axle pad and spring. It is tapered about 1/4" to 3/16". On the right side the 1/4" is toward the rear of vehicle. Left side it has the 3/16" side toward the rear. That makes no sense to me. It would think both sides should have the thicker side toward the front to angle the diff up toward the trans. I will measure angles at the joints tomorrow.</p><p>Thanks to all for input.</p></blockquote><p></p>
[QUOTE="Brian, post: 433264, member: 19943"] I will take pics tomorrow and also do a better job of measuring angles. Visually looking at the springs, there is a shim between axle pad and spring. It is tapered about 1/4" to 3/16". On the right side the 1/4" is toward the rear of vehicle. Left side it has the 3/16" side toward the rear. That makes no sense to me. It would think both sides should have the thicker side toward the front to angle the diff up toward the trans. I will measure angles at the joints tomorrow. Thanks to all for input. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Driveshaft angle?
Top
Bottom