Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Do I need to install manual hubs?
Reply to thread
Message
<blockquote data-quote="smgager" data-source="post: 428521" data-attributes="member: 19275"><p>I would second Jeepjoe43's recommendation for a CV front drive shaft if you go with a solid front shaft considering you are driving on the HWY a good bit. You will also need to remove the front drive shaft if you flat tow as your transfer case's neutral is not a true neutral. You are fine with the CAD so long as your front locker is in open. </p><p></p><p>Have you considered leaving the CAD?</p><p></p><p>I went with 4.56 with my 31s and I wish I would have gone with 4.88 or 5.13 for gears.</p><h4></h4></blockquote><p></p>
[QUOTE="smgager, post: 428521, member: 19275"] I would second Jeepjoe43's recommendation for a CV front drive shaft if you go with a solid front shaft considering you are driving on the HWY a good bit. You will also need to remove the front drive shaft if you flat tow as your transfer case's neutral is not a true neutral. You are fine with the CAD so long as your front locker is in open. Have you considered leaving the CAD? I went with 4.56 with my 31s and I wish I would have gone with 4.88 or 5.13 for gears. [HEADING=3][/HEADING] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Do I need to install manual hubs?
Top
Bottom