Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Do I need to install manual hubs?
Reply to thread
Message
<blockquote data-quote="jeepjoe43" data-source="post: 428469" data-attributes="member: 19255"><p>Already re-geared, that's definitely a plus!</p><p>Going for 4.88s in mine, but i just have the wind up motor.</p><p>Currently running 32s, but not I'm not planning on anything bigger than 33s.</p><p>Wasn't planning on doing a gear swap just yet, but when the D35 turned out to be made from tin foil....</p><p>The heck if i'm going to put a 35 back in, so I ordered an East Coast Gear Supply custom bolt in D489 (JK D44) with 35 splines.</p><p>Since the new rear will be 4.88s and the front will have to be matched, so now's the time to go for 30 splines there, less the CAD.</p><p>OX locks in both to accommodate the bigger shafts. I'll never break them, and I'm down with that!</p></blockquote><p></p>
[QUOTE="jeepjoe43, post: 428469, member: 19255"] Already re-geared, that's definitely a plus! Going for 4.88s in mine, but i just have the wind up motor. Currently running 32s, but not I'm not planning on anything bigger than 33s. Wasn't planning on doing a gear swap just yet, but when the D35 turned out to be made from tin foil.... The heck if i'm going to put a 35 back in, so I ordered an East Coast Gear Supply custom bolt in D489 (JK D44) with 35 splines. Since the new rear will be 4.88s and the front will have to be matched, so now's the time to go for 30 splines there, less the CAD. OX locks in both to accommodate the bigger shafts. I'll never break them, and I'm down with that! [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Do I need to install manual hubs?
Top
Bottom