Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Center Axle Disconnect Replacement Options
Reply to thread
Message
<blockquote data-quote="T-Rex Jeepster" data-source="post: 435495" data-attributes="member: 19821"><p>All good...My Jeepin' is light duty maybe drive off in a field or down a dirt road....Believe me, Got a Master course in installing inner seals on the D-30 with the drivers side going in smooth as butter but destroying four starboard side ones by trying to drive them in from the port side using a 36mm impact socket.</p><p>The socket matches up very well to the skirt of the seal, But we just couldn't get them to seat straight. Wound up using the all-thread/washer set up that the</p><p>Jeep solid dude posted on YT, And it worked like a dream. Have put about three hundred miles on them and everything is dry. Dude I really appreciate your knowledge and if you can explain to me the how to's and what to's to make the 4WD engage/disengage after I remove the CAD and two piece axle I'd be beholding to ya'.......</p></blockquote><p></p>
[QUOTE="T-Rex Jeepster, post: 435495, member: 19821"] All good...My Jeepin' is light duty maybe drive off in a field or down a dirt road....Believe me, Got a Master course in installing inner seals on the D-30 with the drivers side going in smooth as butter but destroying four starboard side ones by trying to drive them in from the port side using a 36mm impact socket. The socket matches up very well to the skirt of the seal, But we just couldn't get them to seat straight. Wound up using the all-thread/washer set up that the Jeep solid dude posted on YT, And it worked like a dream. Have put about three hundred miles on them and everything is dry. Dude I really appreciate your knowledge and if you can explain to me the how to's and what to's to make the 4WD engage/disengage after I remove the CAD and two piece axle I'd be beholding to ya'....... [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Center Axle Disconnect Replacement Options
Top
Bottom