Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Center Axle Disconnect Replacement Options
Reply to thread
Message
<blockquote data-quote="T-Rex Jeepster" data-source="post: 435478" data-attributes="member: 19821"><p>OK.....Replaced both seals this past weekend and found out that I could only use the new aluminum outer dust shield "Plug" on the drivers side because of the larger diameter axle on the passenger side. I have no problem going back in and eliminating the CAD and one piece the starboard axle....</p><p>But, I can't find anything on YT or the forums on what you have to do to get the 4X4 back on line sans CAD. Any links available?</p></blockquote><p></p>
[QUOTE="T-Rex Jeepster, post: 435478, member: 19821"] OK.....Replaced both seals this past weekend and found out that I could only use the new aluminum outer dust shield "Plug" on the drivers side because of the larger diameter axle on the passenger side. I have no problem going back in and eliminating the CAD and one piece the starboard axle.... But, I can't find anything on YT or the forums on what you have to do to get the 4X4 back on line sans CAD. Any links available? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Center Axle Disconnect Replacement Options
Top
Bottom