Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Bolt Size Help!
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 429981" data-attributes="member: 18789"><p>It is an awesome tool for sure. I kind of want to improve upon it though. It's on a hard fixed cable that can't be taken apart. I need be ab le to take the fittings off so I can freely install them. It's really difficult to test a hole in a tight spot on the jeep if I have to drag the cable and all the other fittings while I try them out on a hole. Especially because I have to spin the whole cable as I spin the fitting. I need a quick way that I can put like a cable lock on one end, and quickly remove by unthreading a thumb screw or something. The only downside then is taking all the fittings to get to the one you want, then putting them all back on in order. It would be nice if instead, the fittings could unclip themselves from the cable, and then clip back on in the right spot. </p><p></p><p>Yeah an inch is 25.4mm so it's somewhere between and inch and 25MM. I tried looking in the Mopar parts manual but didn't find it. But anything from 15-25mm would be fine I'm sure. That bolt really does not do much in the grand scheme.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 429981, member: 18789"] It is an awesome tool for sure. I kind of want to improve upon it though. It's on a hard fixed cable that can't be taken apart. I need be ab le to take the fittings off so I can freely install them. It's really difficult to test a hole in a tight spot on the jeep if I have to drag the cable and all the other fittings while I try them out on a hole. Especially because I have to spin the whole cable as I spin the fitting. I need a quick way that I can put like a cable lock on one end, and quickly remove by unthreading a thumb screw or something. The only downside then is taking all the fittings to get to the one you want, then putting them all back on in order. It would be nice if instead, the fittings could unclip themselves from the cable, and then clip back on in the right spot. Yeah an inch is 25.4mm so it's somewhere between and inch and 25MM. I tried looking in the Mopar parts manual but didn't find it. But anything from 15-25mm would be fine I'm sure. That bolt really does not do much in the grand scheme. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Bolt Size Help!
Top
Bottom