Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Body panel replacement
Reply to thread
Message
<blockquote data-quote="Justin Schuring" data-source="post: 432419" data-attributes="member: 19358"><p>When my Jeep was drivable I spun out in the snow and hit a telephone pole. That was fun haha. The damage caused was to the rear quarter above the wheel well. I don’t know if I want to do the body work, pulling the dent, bondo, etc, or just buy a new panel. It bent the top where the rail runs for the soft top. I’ve never done any body panels and want to know if it’s a bolt up job or do I need to weld the new panel on? Thanks</p></blockquote><p></p>
[QUOTE="Justin Schuring, post: 432419, member: 19358"] When my Jeep was drivable I spun out in the snow and hit a telephone pole. That was fun haha. The damage caused was to the rear quarter above the wheel well. I don’t know if I want to do the body work, pulling the dent, bondo, etc, or just buy a new panel. It bent the top where the rail runs for the soft top. I’ve never done any body panels and want to know if it’s a bolt up job or do I need to weld the new panel on? Thanks [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Body panel replacement
Top
Bottom