Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
AX-5 install on 2.5L (Almost)
Reply to thread
Message
<blockquote data-quote="Jeeperhiker" data-source="post: 425166" data-attributes="member: 18645"><p>I ran into the same problem. What helped the most was separating the transfer case from the transmission. With the both together it was just too much mass for me to handle on my own. After I split them I was able to wrestle it in that last quarter inch. It also makes aligning the splines on your input shaft easier as you can give it a little turn from the output shaft.</p></blockquote><p></p>
[QUOTE="Jeeperhiker, post: 425166, member: 18645"] I ran into the same problem. What helped the most was separating the transfer case from the transmission. With the both together it was just too much mass for me to handle on my own. After I split them I was able to wrestle it in that last quarter inch. It also makes aligning the splines on your input shaft easier as you can give it a little turn from the output shaft. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
AX-5 install on 2.5L (Almost)
Top
Bottom