Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Auto to manual swap?
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 427833" data-attributes="member: 18789"><p>That deadjeep one is 94+. I can tell by looking at the hollow sleeve going over the input shaft. The 93 and earlier models don't have that. Their "bearing retainer" plate is relatively flat. The 94+ has the sleeve built in for the external slave throwout bearing to ride on. I just noticed that dead jeep trans doesn't have a bell housing though, so you will need to buy one. The automatic's is built in so there is nothing to save and reuse.</p><p></p><p>The Facebook one doesn't seem bad, if it shifts decently. At least it comes with good parts like the shifter, but if it's from a TJ you likely won't want that shifter. The TJ console setup is much different. If I recall, the TJ shifter rod puts the ball in a really weird spot for the driver in a YJ and ends up hitting either the seat or the console or something. Could always give it a try, but plan on buying a YJ shifter. If you send pics of the shifter I can recognize what it came out of. I would buy a new throwout bearing, I would never reuse an old one. Too much work to replace if that old one for some reason decided to kick the can. Clutch fork is nice though, one less thing to buy. Nothing wrong with reusing that.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 427833, member: 18789"] That deadjeep one is 94+. I can tell by looking at the hollow sleeve going over the input shaft. The 93 and earlier models don't have that. Their "bearing retainer" plate is relatively flat. The 94+ has the sleeve built in for the external slave throwout bearing to ride on. I just noticed that dead jeep trans doesn't have a bell housing though, so you will need to buy one. The automatic's is built in so there is nothing to save and reuse. The Facebook one doesn't seem bad, if it shifts decently. At least it comes with good parts like the shifter, but if it's from a TJ you likely won't want that shifter. The TJ console setup is much different. If I recall, the TJ shifter rod puts the ball in a really weird spot for the driver in a YJ and ends up hitting either the seat or the console or something. Could always give it a try, but plan on buying a YJ shifter. If you send pics of the shifter I can recognize what it came out of. I would buy a new throwout bearing, I would never reuse an old one. Too much work to replace if that old one for some reason decided to kick the can. Clutch fork is nice though, one less thing to buy. Nothing wrong with reusing that. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Auto to manual swap?
Top
Bottom