Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
95 Timing Chain Replacement
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 432393" data-attributes="member: 18789"><p>I opted for a new one for a few reasons, mainly because my cover was disgusting and it didn’t have the proper stickout for the AC idler pulley to spin freely. </p><p></p><p>There is no bearing but you could definitely clean up your cover and install a new seal into it just fine. </p><p></p><p>What how to have you been watching? My replacement chain from cloyes worked out nice and snug. </p><p></p><p>I don’t know what needs to be degreed means, all I did was took the timing cover off, and rotated the crankshaft with a large ratchet until the dots on the two sprockets lined up. Then zip out the crank bolt with an impact, orient your new sprockets and chain (may have to set the sprockets in the chain multiple times to get them to actually line up) and then slide them onto the crankshaft and camshaft. It was a pretty painless procedure overall.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 432393, member: 18789"] I opted for a new one for a few reasons, mainly because my cover was disgusting and it didn’t have the proper stickout for the AC idler pulley to spin freely. There is no bearing but you could definitely clean up your cover and install a new seal into it just fine. What how to have you been watching? My replacement chain from cloyes worked out nice and snug. I don’t know what needs to be degreed means, all I did was took the timing cover off, and rotated the crankshaft with a large ratchet until the dots on the two sprockets lined up. Then zip out the crank bolt with an impact, orient your new sprockets and chain (may have to set the sprockets in the chain multiple times to get them to actually line up) and then slide them onto the crankshaft and camshaft. It was a pretty painless procedure overall. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
95 Timing Chain Replacement
Top
Bottom