Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
91 Sahara euro tail light conversion
Reply to thread
Message
<blockquote data-quote="SuperFrankieOSX" data-source="post: 437332" data-attributes="member: 20186"><p>UPDATE: I solved the License plate light issue by installing a plate frame with a built in LED light, hooked it up to a weather connector and then hooked that into the light circuit, works well! I added a factory third brake light by installing the factory style contact pin set up in the tailgate using new pin seals (OMIX-ADA Sliding door Grommet 12029.41). I used rubber grommets to fill the holes in the tailgate to let the wires through and fluid filmed the inside of the tailgate while it was unsealed to protect it from rust. I pined the 3rd brake light with weather connectors so i can disconnect and remove it easily or swap it (which I will, because its a TJ housing so it's way too tall for my YJ carrier and spare, I have an all metal YJ one on the way). I just connected the pins on the body to the brake light circuit using bullet connectors to connect to the pins. Drilling was required but I just looked at my junk '94 for reference of where to drill and whatnot.</p></blockquote><p></p>
[QUOTE="SuperFrankieOSX, post: 437332, member: 20186"] UPDATE: I solved the License plate light issue by installing a plate frame with a built in LED light, hooked it up to a weather connector and then hooked that into the light circuit, works well! I added a factory third brake light by installing the factory style contact pin set up in the tailgate using new pin seals (OMIX-ADA Sliding door Grommet 12029.41). I used rubber grommets to fill the holes in the tailgate to let the wires through and fluid filmed the inside of the tailgate while it was unsealed to protect it from rust. I pined the 3rd brake light with weather connectors so i can disconnect and remove it easily or swap it (which I will, because its a TJ housing so it's way too tall for my YJ carrier and spare, I have an all metal YJ one on the way). I just connected the pins on the body to the brake light circuit using bullet connectors to connect to the pins. Drilling was required but I just looked at my junk '94 for reference of where to drill and whatnot. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
91 Sahara euro tail light conversion
Top
Bottom