Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
258/4.2 crankshaft
Reply to thread
Message
<blockquote data-quote="Gilaguy23" data-source="post: 431214" data-attributes="member: 19498"><p>The data I see indicates their the same. But Im sure others will chime in on that question. Aside from the crank question you might consider checking/replacing the AX input bearing or mainshaft bearings. Id also closely check the end of the trans shaft with a dial indicator to see if it has runout from somebody screwing it up it from a bad clutch installation.</p></blockquote><p></p>
[QUOTE="Gilaguy23, post: 431214, member: 19498"] The data I see indicates their the same. But Im sure others will chime in on that question. Aside from the crank question you might consider checking/replacing the AX input bearing or mainshaft bearings. Id also closely check the end of the trans shaft with a dial indicator to see if it has runout from somebody screwing it up it from a bad clutch installation. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
258/4.2 crankshaft
Top
Bottom