machoheadgames's latest activity
-
machoheadgames reacted to DOWNS's post in the thread 1994 Hunter Green SE “Back to Stock” Thread with
Like.
On the broken studs for screwing on the shift knobs. I forget the thread pitch of the knobs but it's an easily obtainable bolt. I cut... -
machoheadgames replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.It’s 3/8-16 - that welding trick would definitely work. I had no welding capabilities and the new stick was like $40 at the time so...
-
-
machoheadgames reacted to DOWNS's post in the thread What did you do in the garage / driveway today? with Like.
My parts got delayed a day and arrived late, so I didn't get around to wrapping up the transmission swap until today. Of course, my...
-
machoheadgames replied to the thread 89 YJ high beams stuck on.Hmmm, yeah in that case it could be the rod, could be the column mounted dimmer switch, or could be the wiper or turn signal switch...
-
machoheadgames replied to the thread Help with 4WD indicator light.You will slightly rub the leaf springs with 31’s but you can just adjust the steering stops a bit with a washer under each one and it...
-
machoheadgames replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.My biggest problem with the boots is that I was tired of the self tappers not being tight or even snug on some of them, so I tried to...
-
machoheadgames replied to the thread Help with 4WD indicator light.I think that would be about perfect. 31’s on stock rims is a good setup. I’m to the point where I don’t like aftermarket wheels. For my...
-
machoheadgames replied to the thread Help with 4WD indicator light.Don’t get me wrong, a lot of people run the posi lock and like it. It just doesn’t appeal to my tastes. Give it a shot if you think it...
-
machoheadgames replied to the thread Help with 4WD indicator light.It’s very odd that you’re getting vacuum on the plug but when it’s plugged into the tcase switch, you don’t get any vacuum on either...
-
machoheadgames replied to the thread Help with 4WD indicator light.Well, how you think it works is how it’s supposed to work. Vacuum is always applying suction at the axle actuator on one of the two...
-
machoheadgames replied to the thread Help with 4WD indicator light.How are you able to press on the ball and then feel vacuum at the axle? In other words, where are you testing and finding “no air flow”...
-
machoheadgames replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.Are you just needing to replace the isolator and clip and are they already bad? That job is not too terrible, because the isolator...
-
machoheadgames replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.It’s been a while, years ago I looked into their 231 shifters. There was a cable one and a non cable. The non cable was very similar to...
-
machoheadgames replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.Yeah I’ve sheared a transfer case knob stud before. I think I had installed the jam nut too tight. I don’t really remember. But anyways...
-
machoheadgames reacted to DOWNS's post in the thread 1994 Hunter Green SE “Back to Stock” Thread with Like.
Yeah the boots are no fun, but they make a huge difference in drivetrain heat getting into the cab.
