Gilaguy23's latest activity
-
GGilaguy23 replied to the thread Single Point Injection Wiring.So now that you have a jeep and all its issues you are dealing with, is it really true Rovers are poorly made? Couldn't resist ;)
-
GGilaguy23 replied to the thread Oil pressur.No cause when you shut ot off much of the oil drains out anyhow. Id start with a bad part or gauge/ground issue.
-
GGilaguy23 replied to the thread WTB: Factory YJ wheels.Bummer, I gave 4 of those away a while back. Collins bros jeep has them likely but shipping might kill you depending on your location.
-
GGilaguy23 replied to the thread WTB: Factory YJ wheels.There are several different ones used, post a pic so all can see what you need. . Try Craigslist like I did and found 4 steelies for $50.
-
GGilaguy23 replied to the thread 4.0 exhaust header replacement.I also used a Dorman on my 95/4.0 and one on a V6 mustang. Like Macho I never racked up much in miles on either but they fit good and...
-
GGilaguy23 replied to the thread Need advice on YJ that caught my eye.Possible the PO dumped cheap hyd fluid in the trans cause it was on hand?
-
GGilaguy23 replied to the thread Rough idle, stalls and dies after a few miles.How did it run before you changed out those 7 things?
-
GGilaguy23 replied to the thread Should I get a hard top or a soft top?.Hard top, the bad. Must be a planned removal and storage place. Ventilation/noise sucks with the door off or door window rolled down...
-
GGilaguy23 replied to the thread How do you unplug the idiot light panel on dashboard?.On my 91 the little bulbs burned out or were corroded at the base. Might try cleaning or replacing the bulbs before swapping the entire...
-
GGilaguy23 replied to the thread 89 YJ sputtering through intake and no power after new motor (2.5, manual transmission).You need to talk with the engine shop or seller and tell them what you've found. They might deny warranty if you screw with it to much...
-
GGilaguy23 replied to the thread 95 YJ grinding noise - 2wd to 4h while moving.2wd to 4wd hi ONLY while moving up to 55mph or something like that. DO NOT try to shift onto low 4x4 unless your barely moving,like...
-
GI would highly suggest sending it to Mark at Wrangler Fix: https://wranglerfix.com/product/jeep-wrangler-module-test/ He is beyond a...
-
GGilaguy23 replied to the thread 89 YJ sputtering through intake and no power after new motor (2.5, manual transmission).IMO you'd have to have one huge vac leak to cause what you describe. Also typically the idle speed would be quite a bit higher with a...
-
GGilaguy23 replied to the thread 89 YJ sputtering through intake and no power after new motor (2.5, manual transmission).Have you double checked all the connections you undid when you swapped engines? Pop the dist cap off and see how much play is in the...
-
GGilaguy23 replied to the thread 89 YJ sputtering through intake and no power after new motor (2.5, manual transmission).Is the miss an even miss like in a couple cylinders are not firing? Or is it random sputter?
