Recent content by 952.5YJ

Hi guys, I’m replacing my lower steering column bearing. I have it slid about 1 inch up the column shaft but it is starting to telescope up into the cabin towards the steering wheel. I can push it in more and get the retainer to seat with the e clip. Could I try pulling down on the shaft with...

Just an update. I have been driving with no issues the last few days with no issues with the PF9002 from Rock Auto. I did have the clutch pedal stick down a couple of times the first few miles but it came back up slowly and has been fine since also the noise at the pushrod went away. If anyone...

It was driving ok with the third assembly but the pedal felt like it was sticking a couple of times. One thing I noticed from the original one is the rubber boot around the master cylinder has several vent holes the new one only has one tiny hole. I am wondering if vacuum may be holding the...

I put the one from Rock Auto in today it had the normal push down that you mentioned but the straps are not snapping off on this unit, I had a friend push on the clutch pedal so I could watch, the t comes up to the flange on the straps but is just shy of enough force to snap them off. Also the...

I ordered a Carquest one off RockAuto. Hopefully third time’s a charm. When I installed the last two I had to push the piston on the slave cylinder in some against the fork cup to get the bolts in. Really they are studs but the nuts are stuck on them. I think it was like that on the one I did...

On my 95 2.5 the original 30 year old clutch master cylinder started to leak a few days ago, I replaced it with a pre bled Duralast master-slave full assembly and it started leaking at the master a few miles later. I replaced that with a Doorman pre bled full assembly and that one lasted a few...