1995 2.5L Build "Clifford"

Mr_Seth

New Member
Joined
Apr 10, 2021
Messages
4
Location
Loveland, CO
Hey guys, here is my Wrangler 2.5L build.

First Mods:
1, Jerry Can with mounts
2. New master/slave cylinder
3. New steering shaft
4. New Dizzy cap, wires, coil, spark plugs
5. Rebuilt front end
6. New air intake
7. New Soft top (Rampage)
8. New driver's floorpan
9. New Kenwood Stereo
10. New Sony 3-way dash speakers
11. Floors painted with bedliner, carpet cleaned and re-installed
12. New Hankook Dynapro 32" AT2's
13. New take-off 2010 Rubicon 18" Wheels
14. Hi-Lift with mounts
15. Midland GMRS Radio with RAM mounts
16. Dash accessory bar
17. Fender trim (too much rust)
18. Billet 1.25" 5x4.5 to 5x5 wheel adapters
19. Re-welded stock carrier with new 5x5 pattern
20. New engine mounts w/bushings
21. 36 Tooth short-shaft speedometer gear


Next Mods:
1. Posi-Lok system for front axle.
2. Waterproof subwoofers
3. Offroad Lights (considering Hella 500)
4. Winch and winchplate
5. Engine overhaul at 140k miles
6. Clutch replacement at 140k miles

Original Photos: (Day 1 of ownership. 4.5" lift, steering all over the place, woof)

51148980592_61bb6dfdd4_c.jpg

51148980607_ff58881653_c.jpg

51148980912_7bfde13b22_c.jpg


Most Recent: (4/29/2021)

51149654421_e90f67209e_c (1).jpg
51150438689_a226d926a5_c.jpg
51150439064_e2833de062_c.jpg
51150762245_1f684d682f_c.jpg
51149654896_1f9e0a43ee_c.jpg
51150759490_c264648aaa_c.jpg



The DMV here in Larimer County, CO has been terrible with their processing times and appointments. My appointment is May 5 where I'll finally be able to get plates on it.

Maybe thinking about fabricating a hoop for the front bumper to place lights on in the near future, and have a winch+plate picked out to mount on the original.

Stay tuned for more!!!!