Latest activity Postings About
-
-
TMight be the crankshaft sensor isn't working so the ECM doesn't know the engine is turning over.
-
TTimberTim replied to the thread Have you seen pre-fabricated parts to move seat / slider closer to wheel - 1992 Wrangler.I have a 91 yj and had to move the stock seat back 2 or 3 inches. I simply re-drilled the 4 holes in the top of the seat pedestal and...
-
TTimberTim replied to the thread Loss of power.No Joy. I still had a flat spot. And when I wiggled the CPS plug I caused a major miss at Idle. I removed the CPS plugs nut and keeper...
-
TTimberTim replied to the thread Loss of power.I replaced, plugs, plug wires, Distributor Cap and rotor. that made a remarkable difference but there's still a small flat spot at high...
-
TTimberTim replied to the thread Loss of power.I been JINXED, now my "91" 2.5L is losing power at high RPM's. Grrrrrr!!
-
TTimberTim replied to the thread Loss of power.this is what I was thinking, remove the coil from the jeep and give it a shake, if it rattles it has overheated and needs replaced
-
TI'm going with coil. A weak spark will not ignite the rich mixture that comes with loading it down. The only non China coil that I...
-
TTimberTim replied to the thread No power to the fuel pump?.I just went through a similar situation with my 91 yj , the starter motor would turn the engine over nice and strong but the engine...
-
TTimberTim replied to the thread Pop noise, then Jeep died, now it won't restart.pull a plug wire and check for spark while you turn it over, if you have spark dribble some gas down the carb and see if it fires off...
-
-
Loading…
-
Loading…
