Latest activity Postings Images About

• • S

    Smiling_JIm replied to the thread Runs great but has a stumble at half throttle.

    Cleaned and re-crimped the 2 pin sockets on the Crank Position Sensor (it's new). Seems to run a little better, still getting a mild...

    Jan 17, 2023
  • S

    Smiling_JIm replied to the thread Runs great but has a stumble at half throttle.

    Guys, Need your thoughts on this.... ;)

    Jan 12, 2023
  • S

    Smiling_JIm posted the thread Runs great but has a stumble at half throttle in YJ General Discussion.

    89 YJ Wrangler 2.5L - 19k miles on new engine. Runs great and has good power, except a slight stumble between 2k to 3k rpm. All vacuum...

    Jan 11, 2023
  • S

    Smiling_JIm replied to the thread What is this sensor on my 89 Wrangler YJ 2.5?.

    Ya, when I turn the Cable Knob, to engage the Front 4x4, the light goes on.

    Dec 31, 2022
  • S

    Smiling_JIm replied to the thread What is this sensor on my 89 Wrangler YJ 2.5?.

    Thanks Guys! I had Jeep Doctor install a front 4x4 Cable, to get rid of the Vac System. So, that explains it. They cut it, since it was...

    Dec 31, 2022
  • S

    Smiling_JIm replied to the thread What is this sensor on my 89 Wrangler YJ 2.5?.

    Ya, it has only the 1 Vac Port on the front, and 1 signal wire out the bottom. It has to be some sort of 'Condition Switch'. Such as Ya...

    Dec 27, 2022
  • S

    Smiling_JIm replied to the thread What is this sensor on my 89 Wrangler YJ 2.5?.

    Any Ideas!

    Dec 27, 2022
  • S

    Smiling_JIm replied to the thread What is this sensor on my 89 Wrangler YJ 2.5?.

    Is it a Vaccuum Solenoid Valve, or a Vacuum Sensor?

    Dec 26, 2022
  • S

    Smiling_JIm posted the thread What is this sensor on my 89 Wrangler YJ 2.5? in YJ General Discussion.

    This sensor, on my 89 YJ 2.5L, is on the Firewall below the battery, and near the Vacuum Canister. The PO pulled the Hose, and cut the...

    • 

    Dec 25, 2022

  Show older items
• Loading…
• Loading…
• Loading…